← Circuit

step16a

By | Published February 14, 2014 | Full size is 2560 × 1920 pixels

Step 16 (1/3): Add the resistors to the colour sensor module

  1. Connect the 220 Ohm resistor between the top side of terminal 3 and the top side of terminal 4.
  2. Connect the 22 kOhm resistor between the top side of terminal 2 and the top side of terminal 4.
  3. Tighten the screws in the top halves of all four terminals.
Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

Gravatar
WordPress.com Logo

You are commenting using your WordPress.com account. ( Log Out /  Change )

Google photo

You are commenting using your Google account. ( Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. ( Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. ( Log Out /  Change )

Cancel

Connecting to %s